Repository navigation
TORUS Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Creates a solid torus (a ring) from a center, a ring radius and a tube radius.
| Command | TORUS |
| Aliases | TOR |
| Ribbon | Model tab › Create panel (Box drop-down) |
| Web app | Available |
| Since | 0.4.7 |
- At
Specify center point or [3P/2P/Ttr]:, pick the center of the torus, or type an option. - At
Specify radius or [Diameter] <100.0000>:, pick a point or type the radius of the ring (center to tube center). - At
Specify tube radius or [2Point/Diameter] <25.0000>:, pick a point or type the radius of the tube.
Press Enter at a radius prompt to accept the value shown in < >. A preview of the torus follows the cursor.
| Option | What it does |
|---|---|
3P (3P) |
Sets the ring by three points on it. |
2P (2P) |
Sets the ring by the two end points of its diameter. |
Ttr (T) |
Select two tangent objects, then give the ring radius. The center is placed tangent to both. |
Diameter (D) |
At a radius prompt, asks for a diameter instead. |
2Point (2P) |
At the tube prompt, sets the tube by the two end points of its diameter. |
- The torus lies on the current working plane (the current UCS).
- The last ring and tube radii are offered as defaults the next time you run the command in the same session.
- Both radii must be greater than zero.
SPHERE · CYLINDER · BOX · CONE · UNION · SUBTRACT
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference