Repository navigation
POLYSOLID Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Creates a wall-like 3D solid of a set height and width, along a path you draw or along an existing line, arc, circle, ellipse, polyline or spline.
| Command | POLYSOLID |
| Aliases | PSOLID |
| Ribbon | Model tab › Create panel (primitives drop-down) |
| Web app | Available |
| Since | 0.7.0 |
- The command line shows the current height, width and justification.
-
Specify start point or [Object/Height/Width/Justify] <Object>:pick a start point, or type an option. Press Enter to choose an object. -
Specify next point or [Arc/Undo]:pick the next point. After three points, Close is offered too. - Press Enter to finish the solid.
To follow an existing object, type O (or press Enter at the first prompt) and then Select object:.
| Option | What it does |
|---|---|
Object (O) |
Builds the solid along a line, arc, circle, ellipse, polyline or spline you select. |
Height (H) |
Sets the wall height. The default is 80. |
Width (W) |
Sets the wall width. The default is 5. |
Justify (J) |
Places the wall to the Left, Center or Right of the path. The default is Center. |
Arc (A) |
Continues with arc segments. |
Close (C) |
Closes the path back to the start point. |
Undo (U) |
Removes the last segment. |
Direction (D) |
In arc mode: sets the tangent direction at the arc's start. |
Line (L) |
In arc mode: goes back to straight segments. |
Second point (S) |
In arc mode: draws the arc through a second point and an end point. |
- If a supported object is already selected when you start the command, pressing Enter at the first prompt uses it.
- With Object, the source object is deleted when
DELOBJis not 0, unless it is on a locked layer. - Height, width and justification are remembered for the next run.
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference