Skip to content

BOX Command

Hakan Seven edited this page Nov 8, 2026 · 1 revision

BOX (Command)

Creates a 3D solid box or cube.

Command BOX
Ribbon Model tab › Create panel
Web app Available
Since 0.1.0

Usage

  1. Specify the first corner of the base, or type Center to start from the center point.
  2. Specify the other corner of the base, or type an option.
  3. Specify the height, or type 2Point. The box is created.

Options

Option What it does
Center (C) The first point you give is the center of the base. The other corner then sets half the length and width in each direction.
Cube (C) Asks for one length and creates a cube with equal length, width and height.
Length (L) Asks for the length, then the width, then the height. The direction you point in for the length sets the rotation of the box.
2Point (2P) Asks for two points; the distance between them is the height.

Notes

  • The box is built in the current UCS, with its base on the XY plane of that UCS.
  • A negative height builds the box below the base.
  • Zero length, width or height is not accepted; the prompt waits for another value.

Related

WEDGE · CYLINDER · EXTRUDE


Command Reference · System Variables

Clone this wiki locally