Skip to content

CHAMFER Command

Hakan Seven edited this page Nov 8, 2026 · 1 revision

CHAMFER (Command)

Bevels the corner between two lines, or between two adjacent segments of a polyline, by two distances.

Command CHAMFER
Aliases CHA
Ribbon Draw tab › Modify panel
Web app Available
Since 0.1.0

Usage

  1. Run CHAMFER. The prompt shows the current distances, for example "Select first line [D1=… D2=…]:".
  2. Pick the first line, or type an option.
  3. Pick the second line. For a polyline, pick the adjacent segment of the same polyline.
  4. The two lines are cut back by the first and second distance and joined by a new chamfer line.

Options

Option What it does
Distance (D) Asks for the first and then the second chamfer distance. The second distance offers the first as its default. You can also type D 5 or D 5 3 to set both at once.
Multiple (M) Keeps the command running so you can chamfer several corners.
Undo (U) In Multiple mode, undoes the last chamfer.
No trim (N) Keeps the original lines as they are and only adds the chamfer line.
Trim (T) Cuts the original lines back to the chamfer (the default).

Notes

  • Lines, rays, construction lines and polyline segments can be chamfered. Arcs cannot.
  • With both distances 0 and Trim on, the two lines are trimmed or extended to meet in a sharp corner.
  • No trim works only with two separate lines, and needs at least one distance above 0.
  • If the distances are longer than the lines allow, you see "Distance is too large."
  • The Trim setting is shared with FILLET.
  • If an edge of a 3D solid is selected when you start the command, CHAMFER chamfers the solid edge instead, as CHAMFEREDGE does.
  • On the ribbon, CHAMFER is in the Fillet drop-down.

Related

FILLET · CHAMFEREDGE · TRIM · EXTEND


Command Reference · System Variables

Clone this wiki locally