Repository navigation
LOFT Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Creates a 3D solid or surface through a series of cross-section curves, optionally guided by guide curves or a path.
| Command | LOFT |
| Ribbon | Model tab › Create panel |
| Web app | Available |
| Since | 0.1.4 |
- Select cross sections in lofting order, or type an option. Objects you selected before the command start the list in the order you picked them.
- Press Enter when you have at least two cross sections.
- At
Enter an option, press Enter to loft through the cross sections only, or choose Guides, Path or Settings. - The new solid or surface is created and selected.
At the cross-section prompt:
| Option | What it does |
|---|---|
Point (POINT) |
Uses a point as the first or last cross section, so the loft ends in a tip. |
Join (JOIN) |
Picks several connected edges that together form one cross section. Press Enter to finish the group. |
Mode (MODE) |
Chooses Solid or Surface. The default is Solid. |
At the Enter an option prompt:
| Option | What it does |
|---|---|
Guides (GUIDES) |
Select guide curves that control the shape between sections. Press Enter to create the loft. |
Path (PATH) |
Select one path curve. The loft is created as soon as you pick it. |
Cross sections only (CROSSSECTIONS) |
Creates the loft from the sections alone (same as pressing Enter). |
Settings (SETTINGS) |
Opens the settings below. Choose Done or press Enter to return. |
Continuity (CONTINUITY) |
Only with a point end: G0 or G1 continuity at that end. |
Bulge magnitude (BULGE) |
Only with a point end: how far the shape bulges at that end. |
Settings:
| Option | What it does |
|---|---|
Normals (NORMALS) |
Ruled, Smooth, First normal, Last normal, Ends normal, All normal, or Use draft angles. |
Draft angles (DRAFTANGLES) |
Start and end draft angle (0 to 180 degrees). Needs Normals set to Use draft angles. |
Magnitudes (MAGNITUDES) |
Start and end magnitude for the draft angles. Needs Normals set to Use draft angles. |
Closed (CLOSED) |
Yes/No: closes the loft back to the first section. Needs at least three curve sections and no point ends. |
Align direction (ALIGNDIRECTION) |
Yes/No: aligns the direction of the cross sections. |
Undo (UNDO) |
Steps back one choice. |
- Cross sections must be planar curves or regions. Point ends are allowed only at the first or last place, with a curve between them.
- A preview shows the result while you work.
-
DELOBJdecides whether the cross sections, guides and path are deleted afterwards. If a source to be deleted is on a locked layer, the loft is not created. - A surface lofted from single-object sections, with no guides or path, can stay associative and follow later changes to its sections.
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference