Repository navigation
LENGTHEN Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Changes the length of lines, arcs, elliptical arcs, splines and polylines, or the included angle of arcs.
| Command | LENGTHEN |
| Aliases | LEN |
| Web app | Available |
| Since | 0.1.3 |
- At
Select an object to measure or [Delta/Percent/Total/Dynamic]:, pick an object to see its length, or type an option. - Enter the value the option asks for.
- At
Select an object to change or [Undo]:, pick objects near the end you want to change. Each pick changes that object. - Press Enter or Esc to finish.
| Option | What it does |
|---|---|
Delta (DE) |
Adds the length you enter. A negative value shortens the object. |
Percent (P) |
Sets the length to a percentage of the current length. |
Total (TO) |
Sets the total length you enter. |
Dynamic (DY) |
Pick a line, arc or elliptical arc, then pick the new end point. |
Angle (A) |
After Delta or Total, changes an arc by an angle instead of a length. |
Undo (U) |
Undoes the last change made in this command. |
- The end nearest the point you pick is the end that changes.
- Press Enter at the first prompt to reuse the last option. Each value prompt offers the last value as its default.
- Percent and total values must be greater than zero. A total angle must be less than 360 degrees.
TRIM · EXTEND · BREAK · STRETCH
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference