Repository navigation
PLINE Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Draws a 2D polyline: one object made of connected straight and arc segments, with constant or tapering width.
| Command | PLINE |
| Aliases | PL |
| Ribbon | Draw tab › Draw panel |
| Web app | Available |
| Since | 0.1.0 |
- Specify the start point.
- Specify the next point, or type an option. Each point adds a segment.
- Type Arc (
A) to draw arc segments, and Line (L) to go back to straight segments. - Press Enter to finish, or type Close to close the polyline.
Arc segments start tangent to the previous segment unless you choose another way to define them.
In line mode:
| Option | What it does |
|---|---|
Arc (A) |
Switches to arc segments. |
Close (C) |
Draws a straight segment back to the start point and ends the command. Offered once there are at least two segments. |
Halfwidth (H) |
Sets the starting and ending half-width of the next segment. |
Length (L) |
Draws a segment of the length you type, in the direction of the previous segment. |
Undo (U) |
Removes the last vertex. You can undo back to the start point. |
Width (W) |
Sets the starting and ending width of the next segment. |
In arc mode:
| Option | What it does |
|---|---|
Angle (A) |
Specify the included angle, then the endpoint, or CEnter (CE) or Radius (R). |
CEnter (CE) |
Specify the center point, then the endpoint, or Angle (A) or Length (L) of the chord. |
CLose (CL) |
Closes the polyline with an arc tangent to the last segment. C also works. |
Direction (D) |
Specify the tangent direction at the start of the arc, then the endpoint. |
Halfwidth (H) |
Same as in line mode. |
Line (L) |
Switches back to straight segments. |
Radius (R) |
Specify the radius, then the endpoint, or Angle (A) and the chord direction. |
Second pt (S) |
Specify a second point on the arc, then the endpoint. |
Undo (U) |
Leaves the current arc prompt, or removes the last vertex. |
Width (W) |
Same as in line mode. |
- The ending width of a segment becomes the starting width of the next one. The width you set is remembered for the next polyline you draw.
- Clicking on the start point again (for example with an endpoint snap) closes the polyline.
- The polyline already exists while you draw, so you can snap to its earlier segments. Pressing Esc keeps the segments drawn so far.
- The polyline is drawn in the current UCS.
- Edit polylines later with
PEDIT.
PEDIT · LINE · 3DPOLY · RECTANG · POLYGON · EXPLODE · JOIN
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference