Repository navigation
ACONSTRAINT Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Adds an angular dimensional constraint between two lines, to an arc, or from three points.
| Command | ACONSTRAINT |
| Web app | Available |
| Since | 2026.37 |
- Select the first line or polyline segment, select an arc, or press Enter to use 3Point.
- With a line: select the second line. With 3Point: specify the angle vertex, then the first and the second angle constraint points. With an arc: the arc's center and ends are used.
- Specify the dimension line location.
- Enter a value, or a name and value such as
ang1=45. Press Enter to keep the measured angle under the default name.
| Option | What it does |
|---|---|
3Point (3P) |
Defines the angle by a vertex and two points. This is the default. |
- Any current selection is cleared when the command starts; you pick the objects inside the command.
- The constraint gets the next free angular parameter name unless you type one.
- The angle is shown with the drawing's angular precision.
DCANGULAR · DCONSTRAINT · PARAMETERS
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference