Repository navigation
DONUT Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Draws filled rings or filled circles from an inside and an outside diameter.
| Command | DONUT |
| Aliases | DO |
| Ribbon | Draw tab › Draw panel |
| Web app | Available |
| Since | 0.1.3 |
- Specify the inside diameter. Type a value, pick two points, or press Enter to keep the value shown.
- Specify the outside diameter the same way.
- Specify the center of a donut. A preview follows the cursor.
- Keep picking centers to place more donuts of the same size. Press Enter to finish.
- An inside diameter of
0gives a filled circle. - If the inside diameter is larger than the outside one, the two are swapped.
- Each donut is a closed polyline with width, so you can edit it like any polyline.
- The diameters you used are remembered for the next time (
DONUTID,DONUTOD). - Donuts lie in the current UCS.
- The tool is in the slide-out of the Draw panel.
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference