Skip to content

DWFCLIP Command

Hakan Seven edited this page Nov 8, 2026 · 1 revision

DWFCLIP (Command)

Clips a DWF underlay to a rectangular or polygonal boundary, or turns its clipping on, off or removes it.

Command DWFCLIP
Web app Available
Since 2026.40.1

Usage

  1. Select the DWF underlay to clip.
  2. Choose a clipping option, or press Enter for New boundary.
  3. For a new boundary, choose how to draw it, or press Enter for Rectangular.
  4. Draw the boundary. The part of the underlay outside it is hidden.

Options

Option What it does
ON (ON) Turns the existing clipping boundary on.
OFF (OFF) Turns the clipping boundary off, so the whole underlay shows. The boundary is kept.
Delete (D) Removes the clipping boundary.
New boundary (N) Draws a new boundary. If the underlay already has one, you are asked Delete old boundary? [Yes/No] first; No ends the command without changes.

When you draw a new boundary:

Option What it does
Rectangular (R) Pick two opposite corners. This is the default.
Polygonal (P) Pick the corner points one by one. Type U to undo the last point. After three points, type C or press Enter to close the boundary.
Select polyline (S) Pick an existing polyline with at least three vertices; its vertices form the boundary.
Invert clip (I) Switches between hiding the outside and hiding the inside of the boundary. The prompt then asks for the boundary type again.

Notes

  • The selected object must be a DWF underlay. Otherwise the command reports that it was not a DWF underlay.
  • CLIP does the same for references, images, any underlay and viewports.

Related

CLIP · DWFATTACH · DWFADJUST · PDFCLIP


Command Reference · System Variables

Clone this wiki locally