Repository navigation
SWEEP Command
Hakan Seven edited this page Nov 8, 2026
·
1 revision
Creates a 3D solid or surface by sweeping one or more profiles along a path curve.
| Command | SWEEP |
| Ribbon | Model tab › Create panel |
| Web app | Available |
| Since | 0.1.4 |
- Select the objects to sweep (the profiles), or type an option. Press Enter when done.
- Select the sweep path, or type an option to set Alignment, Base point, Scale or Twist first.
- The swept object is created.
At the profile prompt:
| Option | What it does |
|---|---|
Mode (MO) |
Choose Solid or Surface for the result. The default is Solid. |
At the path prompt:
| Option | What it does |
|---|---|
Alignment (A) |
Whether the profile is turned to stand perpendicular to the path (Yes/No). |
Base point (B) |
Pick the point on the profiles that follows the path. |
Scale (S) |
Scale factor from the start to the end of the sweep. Reference sets it from a start length and an end length; Expression takes a formula. |
Twist (T) |
Twist angle along the sweep. Bank lets the profile bank along a non-planar path; EXpression takes a formula. |
- Objects selected before you start are used as profiles.
- The path must be a curve with a real length (line, arc, polyline, spline and similar). A profile cannot be its own path.
- Some paths cannot be used with a scale factor other than 1; you then see "The selected path curve is not valid."
- Wire density of the result follows
ISOLINES.
EXTRUDE · REVOLVE · LOFT · PRESSPULL
Open CAD Studio is free software under the GPL-3.0 licence · Source code · Download · Web app · Discussions
Get started
- Installation
- Your First Drawing
- Tutorials
- The User Interface
- Ribbon Reference
- Workspaces and Toolbars
- Navigating the Drawing
Draw and edit
- Drawing Setup and Units
- Precision Drawing
- Isometric Drafting
- Drawing Objects
- Multilines
- Selecting Objects
- Modifying Objects
- Hatches and Fills
- Layers and Properties
Annotate
Organise and reuse
Present and share
3D
Tools
Reference